To be certified SIPP, all packaging must pass physical performance tests.

If your product:

• is in rigid packaging, and
• weighs <23kg and is non-fragile

OR

• is in flexible packaging, and
• is non-fragile, non-granular, and non-sharp

then you can conduct a self-test to certify as described as demonstrated in the instructions and videos below!

If your product is in rigid packaging and weighs more than 23kg or is fragile and weighs less than 23kg, or your product is in flexible packaging and is fragile, granular, and/or sharp, you cannot self-test. You will need to submit a lab report from an ISTA-6 lab in Amazon’s APASS (Amazon Packaging Support and Supplier Network) network or the Amazon Packaging Lab.

Start numbering on the largest side of the box/mailer, and continue numbering (1-4) by rotating the package to the right. The remaining surfaces are numbers 5-6. Make sure to photograph the undamaged package first. Use this same package throughout the entire test.

Mark 45.7cm and 91.4cm on a table leg or wall. Drop the box/mailer from the height onto the face, edge, or corner in the order listed below.

Drop a fresh corrugate box sized 22.9 x 7.6 x 15.2 cm containing a 1.4kg bag of sand from a height of 91.4cm directly on to the bag without causing material punctures, item damage or seal failure.

You must ensure the structure:

• Provides protection against sortation and distribution
• Is sealed with contents full enclosed
• DOES NOT have excess slack-fill